Summer Starts Here - Save up to 70%
Curt T-Connector Vehicle Wiring Harness Installation - 2017 Chrysler 300C- Video
Today on our 2017 Chrysler 300C, we're going to be taking a look at and showing you how to install the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part number C56235. This is what our wire looks like when it's installed. You can see it's going to live inside the vehicle. This is going to provide you the necessary power to light your trailer. You're going to have three amps per circuit for your stop and turn signals. You're going to has six amps per circuit for your tail lights. When you're not in use, you just simply take it, roll it up. more
7/17/2017 9:14:47 AM
Trailer Wiring Harness Installation - 2012 Chrylser 300C- Video
Today on our 2012 Chrysler 300C, we're going to review and install the Curt T-Connector Custom Fit Vehicle Wiring Harness with 4-Pole Flat Trailer Connector, part number C56145. Now with the Curt Custom Fit Vehicle Wiring Harness with 4-Pole Flat Trailer Connector already installed, let's go ahead and take a look at it. The 4-pole connector is going to store down with the spare tire. By storing it inside, it keeps it out of the inclement weather and prevents buildup of rust and corrosion over time. To use it, we'll simply take it out of the spare tire well and run it out over the threshold. Stay away from the latch, because pinching it off in the latch will damage the wire. However, the weather stripping is thick enough that we can simply close the rear trunk on it. Pull out the wire we need to run to our hitch or accessory, and then when we're done simply roll it up and store it back inside. more
6/10/2015 8:53:07 AM
Trailer Wiring Harness Installation - 2007 Chrysler 300C- Video
Today we are going to install part number 28406 from Tow Ready. We are going to install this on a 2007 Chrysler 300C. The first step we have to do is get into a trunk area. Then we need to take off these wing nuts to take out this carpeting and expose the wiring that we need to get to. We need to do that on both sides. There is a little plastic fastener that would help for it to come apart too. There is the wiring we need to get to right there. Now pull back this trunk panel right here, exposing the battery and spare tire. Then we will take the wing nut on the other side and get to the wiring there too. Lastly we are going to take off this interior panel right here. Starting on our driver side, we will go ahead and disconnect here and install our T-connector. Simply push this red button out the way, press on the end, and it comes right apart. more
8/7/2008 10:52:02 PM
Filter Videos
Filter Videos
